HI, dose anyone know how to wire the G&L MFD split P-bass pickups that come in the late SB-1. I have an original Legacy bass & I just got the MFD pickups in & I can't figure how to wire them stock like in a late SB-1. 1 black & 1 white wire off one of the split & 1 green, 1 black & 1 yellow off the other split. Please post or email me if you know how hbombkillya@aol.com or hbombkillya@comcast.net. -Thanks.

Green and White solder together, blacks to ground, yellow to the pot.

Jim

What about a capacitor for tone?

Dunno the value......probably .047 micro

http://img.photobucket.com/albums/v186/spideyjg/SB-1/SB-1004.jpg

Thank you very much, good lookin out. This forum for G&L has been the lifes blood for my growing G&L collection. Thank you all.

The small thing above the capacitor is a resistor & by the color code it seems to be A 6800ohm unit that i'm sure I won't find just anywhere. I am also wondering if this is stock wiring cause there is shielding in the cavity. I'm still going to wire mine up & see what happens.

SB-1 schematic.... (http://www.glguitars.com/schematics/SB-1_schematic_blockdiagram.pdf)

That wiring is original. I put the shielding in myself on this one.

Jim

Before.........
http://img.photobucket.com/albums/v186/spideyjg/SB-1/04080010.jpg

During.......
http://img.photobucket.com/albums/v186/spideyjg/SB-1/SB-1001.jpg

After....
http://img.photobucket.com/albums/v186/spideyjg/SB-1/SB-1005.jpg

You kick ass Jim, thanks for everything. I got all my parts from radio shack & I'm about to do the deed. I'll let you know how it goes. Thanks -Joe

She Is Done! & it sounds soooo good I can't wait till I bust this out at practice later on today. Thank you you guys for helping out a fellow G&L freak. -Joe