Hey all, I'm replacing the tuners on a Squier, but the holes are a tiny fraction too big for the tuner bushings. They sit in there, but are way too loose to use.

Can anyone suggest a way to fix this without doweling the holes and re-drilling?

use the old bushings? or if its close enough, glue some paper on, and then put in your bushings?

Hi.

Hey all, I'm replacing the tuners on a Squier, but the holes are a tiny fraction too big for the tuner bushings. They sit in there, but are way too loose to use.

Can anyone suggest a way to fix this without doweling the holes and re-drilling?

CA or epoxy will do the trick. Use sparingly though, the mess is a PITA to clean.

Regards
Sam

use the old bushings?

*smack head* I can't believe that didn't occur to me. You sir, are awesome.