This is a search-engine-friendly text mirror of the TalkBass Forums

VIEW FULL LIVE VERSION : Rolled Edges - Fretless


macstanton
04-08-2008, 12:55 PM
I have just had my 67 Hofner Jazz Bass turned into a fretless by master craftsmen Ronnie Griffin of Waycross, Georgia.

What affect would "rolled edges" have on the fretboard ?

Do all uprights have "rolled edges?"

RED5
04-08-2008, 02:45 PM
I have just had my 67 Hofner Jazz Bass turned into a fretless by master craftsmen Ronnie Griffin of Waycross, Georgia.

What affect would "rolled edges" have on the fretboard ?

Do all uprights have "rolled edges?"

If by "Rolled edges"? youmean beveling the edges of the fingerboard? Or just relieving the angle. I do it to my fretless basses It makes for a much more comfortable play. The first I tried was fretles Jazz neck I got from Warmouth. The factory edge was near painful it was so severe. I used a radius block and then a soft sanding pad to just break the edge down to a more round bevel. PLays like....you know, don't make me say it.

Rodent
04-08-2008, 03:00 PM
PLays like....you know, don't make me say it.

plays like processed fatty particulates evacted from the mamory gland on a cow - is this what you didn't want to say?

:D

R

erikbojerik
04-09-2008, 07:25 AM
"Rolled edges" are just the edges of the fretboard rounded over to knock down the edge corner, and is intended to mimic the effect the wear on a well-played older instrument. Some folks actually take a rolling-pin approach to this by compressing the wood, it is just as easy to round over the edge by sanding.

It is one of those small things that greatly increases the comfort/playability of a bass.

RED5
04-09-2008, 08:25 AM
plays like processed fatty particulates evacted from the mamory gland on a cow - is this what you didn't want to say?

:D

R Yah! Like he said.heh!

RED5
04-09-2008, 08:29 AM
"Rolled edges" are just the edges of the fretboard rounded over to knock down the edge corner, and is intended to mimic the effect the wear on a well-played older instrument. Some folks actually take a rolling-pin approach to this by compressing the wood, it is just as easy to round over the edge by sanding.

It is one of those small things that greatly increases the comfort/playability of a bass.

Wish I'd known about you guys when I was building my T-Bird. That fingerboard blank (and to a greater extent the peghead angles) Made me weep. Plays great after all though. Keeping your address.