| Acoustic Image Focus 1 III - in near perfect condition
Sign in to disble this ad
Acoustic Image Focus 1 III - in near perfect condition. ---- $400.00
I'm selling an Acoustic Image Focus 1 III, that I bought new in 2006 (its warranty is good through March 2011).
It was used on less than 5 gigs and is in exactly the same condition as when I bought it.
The only thing that keeps the condition from being perfect in every way is that ever since I bought the amp, it seems that all 1/4" connectors fit too loosely into the 1/4" instrument input, allowing the instrument cable to wiggle in the jack, causing crackling.
On the few gigs that I used the amp it wasn't a problem - I just made sure to not let the cable wiggle. If I were to start using the amp on a regular basis, I would probably just have the input jack replaced.
You could have any amp repair shop do this, or you could send it back to AI, where the work should be done for free, since it is still under warranty.
The price includes shipping anywhere in the CONUS and it comes complete with power cable, speaker cable, manual, bag, and un-signed warranty card.
Specifications System
Frequency Response: 20 Hz - 20 kHz, ±0.5 dB
Distortion: <0.5%, full output, <0.1%, typical
Hum and Noise: -85 dB or better
AC Power: 115V/60 Hz or 230V/50 Hz, switchable
Size: 10x8x3.5 inches
Weight: Less than 5 lb Preamp (Mic and Instrument Inputs through combo jack
Mic Input: 600 ohm balanced, XLR connector
Phantom Power: 38 volts, on/off switch w/LED indicator
Instrument Input: 1 MW impedance, 1/4 inch jack
Direct Out: +4 dB, balanced, XLR connector, ground lift, pre/post EQ selector
Effects Loop: Parallel type with return level control
Bass Control: Shelving type, ±15 dB at 60 Hz
Mid Control: ±15 dB at 650 Hz
Treble Control: Shelving type, ±25 dB at 10 kHz
Notch Filter: >-18 dB sweepable from 30 to 800 Hz
Low Cut Filter: -12 dB/octave sweepable from 30 to 800 Hz Power Amp
Topology: Class D (PWM)
Switching Frequency: 230 kHz
Output Power: >450W (8 ohms), >800W (4 ohms), >1000W (2 ohms)
Minimum Load: 2 ohms
Output Connectors: Neutrik Speakon type (pole 1)
XLR-1/4 in combo jack, 5kW
You can see more pictures of it here:
Feel free to ask questions.
Thanks!
Seth
__________________ "Art and pornography may be in the eye of the beholder, but bad welding is a fact."
Last edited by Scooperman : 02-06-2011 at 09:09 AM.
Reason: Price Change/typo
|