Hello all,
I am selling my deltabass head. here is the info from the manual.
The DeltaBass was designed keeping in mind the value of a lightweight, powerful bass amp. This amp has that and more.
Because the DeltaBass is a lightweight amp, it’s portable enough for any gig or practice. The easy-to-use three-band EQ is so versatile you should have no problem quickly dialing up your sound. Professional features like a Tuner Send, Post-EQ Effects Loop, and a transformer balanced XLR jack with Pre/Post EQ switch will make your next gig a breeze. Notice that we tapped the signal for the XLR before the Volume control (even for the Post EQ Send) so you can adjust your stage volume without tampering with the sound in the mains. This will certainly score some valuable points with your soundman.
FEATURES:
• Buffered tuner send jack
• Post EQ effects loop
• Transformer-balanced XLR jack
• Pre/Post EQ send switch for XLR jack
• Ground lift switch for XLR jack
• Patented DDT power amp compression with defeat switch and LED indicator
• 160 Watts (4 ohm) power amp
MainsVoltage= 120 VAC 60 Hz (Fuse: 5 amps)
230 VAC 50/60 Hz (Fuse: 3.5 amps)
100 VAC 50/60 Hz (Fuse: 6 amps)
PowerConsumption= 200 watts
SYSTEM NOISE:
Typically greater than -85 dB
POWER AMPLIFIER SECTION:
Protection:
Current limit protection circuit.
Thermal protection circuit.
DDTTMspeaker protection circuit with defeat switch.
GENERALINFORMATION:
Minimum load = 4 ohms
DDTTMdynamic range: +12 dB
Input sensitivity: 1 V RMS
Two 1/4" output jacks in parallel.
POWER OUTPUT:
160 watts (25.3 V RMS) into 4 ohms with no more than 0.1%
THD+N
175 watts (26.46 V RMS) into 4 ohms @ 1% THD+N
110 watts (29.66 V RMS) into 8 ohms with no more than 0.1%
THD+N
120 watts (30.98 V RMS) into 8 ohms @ 1% THD+N
NOISE:
Greater than 100 dB below full power @ 8 ohms typically
-105 dB
SETTINGS FOR FOLLOWING MEASUREMENTS
UNLESS OTHERWISE NOTED:
Pre-Gain= 5 (12 o’clock)
Contour= 0 (fully CCW)
Bass= 0 (12 o’clock)
Mid= 0 (12 o’clock)
MidShift= 12 o’clock
High= 0 (12 o’clock)
Master Volume= 5 (12 o’clock)
High Boost= out
Pad= out
DDTTM= Active
INPUT SENSITIVITY(Level to achieve full power):
With Pad Out...
Nominal input:65 mv
Minimum input:3 mv (pre gain and master fully CW)
Maximum input:2.3 volts (maximum signal at input before
clipping occurs)
With Pad (-10dB) In...
Nominal input:205 mv
Minimum input:9.5 mv (pre gain and master fully CW)
Maximum input:7.2 volts (maximum signal at input before
clipping occurs)
EQUALIZATION:
Contour:special EQ curve
Bass:+/-15 dB (shelving type)
Midrange:+/-15 dB (peaking type)
Mid Shift: 200-2 kHz
High:+/- 15 dB (shelving type)
High Boost:+ 10 dB @ 8 kHz
EFFECTS LOOP:
Set for -10 dB with pre @ 5, Master @ 10
TUNER SEND:
Buffered off input jack with no equalization.
XLR OUTPUT (referenced to 1 VRMS= 0dBv):
Pre-Eq selected:-2 dBv
Post-Eq selected:-3 dBv
here is a stock pic
I am asking 145 shipped!
as far as trades, I am open to many things, but especially rackmount wireless units, a similar priced 210, and a rackmount tuner. I am not horribly interested in effect pedals (I have the ones i want for now--but if you have a cool one, give it a shot
), preamps, strings, pickups or small accessories like that.
However, run it by me--the worst I can do is say no
