Newer version of SM-900 - hybrid tube/ss amp. Purchased new in 2003.
Power Handling: Bridge/Mono Mode: 900 Watts @ 4 Ohms, Stereo Mode (per side): 400 Watts @ 4 Ohms
She's got some rack rash, but her face is pretty. She's only been gigged a handful of times, otherwise lived in the studio.
One of the white EQ knobs disappeared -- they're two stage, it just pops inside the outer one. GC can get you these for a couple bucks, I have a different one in there that I've been using just fine. Not wanting to wait a few weeks for one to come in to sell. So, here it be:
These go for $1799 new.
PRICE DROP
$650 shipped
NO TRADES!! Sorry guys. Need the cashish.
FRONT PANEL:
All tube preamp gain stages
Dual independent input jacks compatible for both active and passive instruments
Gain control with LED peak clipping indicator
Limiter with variable threshold control
Exclusive Aural Enhancer circuitry
Master volume control w/clip LED indicator
Active bass and treble controls
2 independent switchable 3-band semi-parametric EQs
EQ footswitch (not included)
Effects blend control / Tuner send / Electronic crossover
Bi Amp Crossover Point Control: 100Hz to 1000Hz
Crossover Slope: 12 dB per octave
REAR PANEL:
Stereo and Mono Effects Loop
Balanced XLR Output with select switch for Line or Direct Mode
Ground lift & pad control
High and Low Crossover Outputs
Power Amp Assign Switch selects Bridge or Stereo Mode
SPEAKER OUTPUTS:
2 - 1/4" jacks each for Left and Right Stereo Out
One Speakon jack each for Left and Right Side Output
One Speakon Output Jack for Bridge Mono Operation
Speaker fuses (x2): 3AG, 10 Amp, Fast Blo
Line Fuse: 3AG, 8 Amp, Slow Blo
INTERNAL:
(1) 12AX7 Preamp Tube
Cooling fan
FREQUENCY RESPONSE: (Power amplifier): -3dB @ 20Hz and 40KHz
SENSITIVITY:
Full output, 8 ohm load, 100Hz
Passive Input Jack: 50 millivolts
Active Input Jack: 200 millivolts
Power Amplifiers (Effects Return Jack "in"):1.6 volts
DiISTORTION:
Power Amplifiers (Effects Return Jack "in"): 0.03% THD
I.M. Distortion: 0.06%
System Distortion
(Gain and Master Volume full, Enhancer at minimum
and Tone controls set flat): 0.4% THD
SIGNAL TO NOISE RATIO: -75dB (<8 millivolts typical)
EQUIVALENT INPUT NOISE: 8.9 microvolts
INPUT IMPEDANCE:
Passive/Active Input: 800kOhms
Active Input: 60kOhms
Effects Return: 27kOhms
OUTPUT IMPEDANCE:
Effects Send: 100 Ohms
Tuner Send: 100 Ohms
XLR:1.5kOhms
