SOLD - thanks for the interest everyone!
OK, too many projects and not enough time so I'm selling a loaded Warmoth 51P body (alder), including a custom red tortoise pickguard, Basslines SCPB-2 Hot P pickup, Gotoh 206 bridge, string ferrules, control plate, battery box, and jack plate.
$225 shipped to lower 48, Paypal preferred.
Body weighs 5.2 pounds, so if you use a Warmoth neck, the build should come in around 9.5 lbs, lighter if you use some other neck. The stock Warmoth pickguard is ugly IMO because the horns are too skinny and ruin the look, so I got a custom red tortoise pickguard for it. I had to shave the pickguard a bit at the bottom of the neck pocket to get it to fit, but the end of the fingerboard covers it (see picture with neck - neck not included). Pickup and control cavity are shielded with copper foil, and wires from pickup, battery box, and bridge ground are all connected and run into the control cavity. I routed the control cavity more back by the tone knob location so that I could install an East BTB-01 preamp, which sounds killer with the single coil P pickup if you decide to go active - it really lends some flexibility to the single P pickup configuration - highly recommended.
Check it out here:
http://bestbassgear.com/btb-01-preamp.htm 
FS: Loaded Warmoth 51P body (alder), vintage creme, red tortoise pickguard... 
sweet body!
