610 Hlf mono bridge

[DBTOYS]

using svt 4 pro in mono bridge when hooking it to the cab there is 2 1/4 inch inputs using the mono bridge cable does it matter witch input on the cab it goes into?????

[DBTOYS]

Does anyone Know?????

[BassmanPaul]

Pretty much all cabinets with a pair of jacks have them wired in parallel. Thus you should be able to use either.

When using an amp in bridge it's advisable to use a speakon cable if the amp is so equipped. In bridge both the tip AND the sleeve are hot with opposite polarities. This is a danger to your amp if you speaker cable comes into contact with another ground and to you personally if you are holding the speaker cable with the amp outputting a signal. It's a simple job to retro fit a cab with a speakon.

Paul

[megadan]

The 610HLF should have speakon jacks all ready. As Paul says you would be well advised to use those for biamping.

In answer to your original question, it doesn't matter which input you use, they are wired together inside the cab.

[DBTOYS]

what if i wanted to run 2 619 hlfs mono bridged ??

[johnk_10]

with two 610HLF's, you'd have a 2 ohm load, so you should make sure that your amp can handle an impedance that low.

[TimK]

I have the same rig svt 4 pro and the 610. I think the svt4 pro can handle 2 ohm loads (not 100% postive though) I think it says that right on the amp, back side lower left underneath the Power amp A output section.

I only one 1 610 though, never used two. That would be sweeet though!

also, I think you can use either 1/4 jack. but I use speakon cable as mention above.

[DBTOYS]

thankx guys the svt 4 pro does do 2 ohms i think i will try it

[BigMac5]

Originally Posted by TimK

I have the same rig svt 4 pro and the 610. I think the svt4 pro can handle 2 ohm loads (not 100% postive though)

Not monobridged, in dual mode it can handle 2 ohm loads..

[DBTOYS]

what type of cable would go from the first cab to the second ??

[RickenBoogie]

a speaker cable/

[Kmose]

run your svt 4pro in stereo and each 610 cab will be getting a 4 ohm load. This is my stage setup and it crushes!