BFM Omni 10 w/BP102's

[77PBass]

I have two 4x10 Hartke XL cabs loaded with Eminence Legend BP 102's. I've tried to sell them but they have more value in the speakers than I can get for the cabs.

I have wanted to add some BFM enclosures to my collection and have thought about having some Omni 10's made and using the BP 102's.

There are people here with a lot of experience with BFM cabs...do you think these speakers will work in this cab?

The speaker Specs are:

Nominal Basket Diameter 10" / 254mm
Impedance 4 or 8 ohms
RMS Power Rating 200 Watts
Frequency Response 40Hz - 2.0kHz
Sensitivity (1W/1m) SPL 92dB
Voice Coil Diameter 2" / 50.8mm
Gap Height 0.312" / 7.92mm
Rec. Enclosure Volume(Sealed) .5-1.1cu. ft./14-31 Liters
Rec. Enclosure Volume(Vented) .9-2.7cu. ft./25-75 Liters

Resonant Frequency (fs) 35 Hz
Impedance (Re) 5.59 ohms
Coil Inductance (Le) 0.83mH
Electromagnetic Q (Qes) .47
Mechanical Q (Qms) 5.36
Total Q (Qts) .43
Compliance Equivalent Vol. (Vas) 91.2 Liters/3.2cu. ft.
Voice Coil Overhang (Xmax) 6.2mm
BL Product (BL) 10.0 T-M
Surface Area Of Cone (Sd) .03345m2

[billfitzmaurice]

Omni 10 was discontinued 2 years ago, and the BP102 was not a suitable driver for it. I only use BP102 in subwoofers.

[77PBass]

Thanks Bill....any suggestions on using those speakers in one of your designs?

[billfitzmaurice]

Originally Posted by 77PBass

Thanks Bill....any suggestions on using those speakers in one of your designs?

Ask here: http://billfitzmaurice.info/forum

[77PBass]

Sorry for being lazy...I guess a Jack 210 would be suitable.

[77PBass]

Upon further investigation, the O12 210 Tallboy looks to be the ticket.