Hello everyone. I am a new member and I have a question about my my amp(s). I have a GK 700RBII and A Hartke HA 3500 amp head that I play through an Ampeg 410 or SWR a Workingpro 15 speaker cabinet (depending on the gig). I'm trying to figure out why my bass sounds distorted in the lower frequencies when I use either amp head with the SWR speaker cabinet. I figured it is either not matched power wise or ohm wise, or my amp settings are not correct. On the GK 700, I'm not sure about the balance of volume, gain, boost, etc. And on the Hartke, the combination of Graphic, tube and solid state gain, low boost/high boost etc. is also hard to balance. What should be my starting point? Oh, yeah, the main basses I use are a Warwick 6 sting thumb bass and a Fender Jazz 5 string,which gives me the most problem with low end balance.
A few threads on this.
Basically it takes 2 10" speakers to equal the sensitivity of 1 15"
But if you mate a 1x15 with a 410 the output of the 4x10 will now be louder than 1x15. And the 1x15 will reach distortion way before the 4x10.
It would take 2 x15 to balance the system out. but unmatched speakers running on no crossover will have phase cancellation.
And cause strange dips or peaks in the overall EQ of your rig.
A better setup would be 2 matching 4x10 or 2 matching 1x15
otherwise to help out a bit dont put the 15 on the bottom of the stack like every horrible bass amp magazine add has shown.
Put the 15 on top so you can hear it better and be able to tell when it runs into distortion.
then save up for a matching rig.
Check your Amps owners manual for getting started tips, most manuals will come with recommended generic knob settings....then dial in from there
I think this is more of an eq question- and if that's correct, try CUTTING the low freq's and boosting the mids. I think you may be asking for too much low end. Bass guitar cuts through thanks to the mids, not the lows.
What are you settings on the GK?
I don't think he's using both at gigs, just one or the other depending on the situation. I'm with RickenBoogie, try cutting the lows.
If you're using the same settings with your 410 as you are with the 15 it's likely the 15 just can't take as much as the 410. Lower bass frequencies, and up mids, maybe lower gain and raise the volume a bit to stay as clean as possible.
OK thanks. I think I understand whats happening now. I think cutting the lows will solve it. What about low mids? I get distortion at around 250 hertz on the graphic.
Cut ANYTHING that sounds bad.
You're probably just asking too much out of the SWR cab.
|All times are GMT -6. The time now is 11:36 AM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.