Eden WT-800 question

bassgod76 · #1 06-20-2011, 01:06 PM

I have an Eden WT-800. I have two cabs. One is an eden 410XLT, the other is an Eden 115XL. Both cabs are 8ohm

I've had the 410 forever, and just mono bridged the amp. I can only mono bridge at 8 ohms.

I assume that daisy chaining the cabs would draw down the ohms to 4 which would not work with the amp mono bridged?

With this in mind, my only choice is to run the amp in stereo without daisy chain?

jjk2007 · #2 06-20-2011, 01:40 PM

If it's an original 800(A) you are correct, you cannot run both cabs off the bridge connection. I would personally run stereo and use the balance knob to control the level of each cab as you see fit. Your other option is to run both cabs off one side, but you lose the control of adjusting levels with the balance knob.

bassgod76 · #3 06-20-2011, 01:41 PM

I had a feeling that was the case. Cool!

babebambi · #4 06-20-2011, 01:57 PM