Fearful 15/6/1 crossover need help (warning Pics inside :p)

[mcapote]

bought on of lelands crossovers for a project. Someone go over how i wire this so I dont mess anything up. My brain isnt working today and I want to finish this box without blowing anything. I thought it was pretty straight fwd of + in on all 3 connected to the speakon + and - in on the 3 to speakon with + and - driver to each driver. but im not sure now.

[Sundogue]

Not sure how the "1" of the 15/6/1 gets wired into it, but here's a layout of the 15/6 if that helps any...

[mcapote]

Originally Posted by Sundogue

Not sure how the "1" of the 15/6/1 gets wired into it, but here's a layout of the 15/6 if that helps any...

that pretty much what i thought. and the 1 should be the same because the + of the 1 should match the + of the 15 according to the designer.

[Sundogue]

Originally Posted by mcapote

that pretty much what i thought. and the 1 should be the same because the + of the 1 should match the + of the 15 according to the designer.

That's what I thought it might be. Never wired up the horn or even saw the board for it before.

[mcapote]

lol after all this crap i had it wired right the first time. my problem was a bad speakon cable.

[mikeddd]

I'm bumping this to verify the the OPs pictures in the first post are 100% correct. These are the best pics of all three crossovers out there. They need to be in the Wiki! (assuming they are correct)

Please LMK if these are correct; I will use them as a build guide. Also, am I correct that the tweeter input and output on the crossover share the same negative terminal? Thank you!!!

[lelandcrooks]

They are correct. And you are correct on the tweeter. Be sure to reverse the polarity at the tweeter.

[mikeddd]

Thank you, Leland! So both the mid and tweet have the polarity reversed, correct?