Markbass CMD 102P question?

osuok88 · #1 09-22-2010, 05:43 PM

Hi
I bought a Markbass bass amp combo CMD 102P and don't have a manual. I would like to buy an 2x10 cab for it and I would like to know how you connect it to the bass amp combo (what cable that I need?). I saw on the back of my Markbass CMD 102P and see a "line out" and "speaker out" so I guess to connect the cab to the "line out". Is this right? Please help
Thank
Vince

equal · #2 09-22-2010, 06:16 PM

No, you would connect your speaker cabinet to your speaker out. You would need to get an 8ohm cabinet, seeing as the amplifier part of the combo runs at 8 or 4 ohms and the speakers already connected are 8 ohms. 8 ohm cab + 8 ohm cab = 4 ohm load.

LuvMusic · #3 09-22-2010, 06:22 PM

You use the speaker output. Also the Jack is a dual function speakon-1/4 in. Connector. If you use a 1/4 in (regular speaker cabinet cable) just plug it into the center of Jack. Make sure your extension cab is 8 ohms.

FYI, you can download a manual from Markbass' website. Hope this helps!

osuok88 · #4 09-22-2010, 08:08 PM

Thank guys. You are very helpful.

**derrellvis69** · #5 09-22-2010, 09:07 PM

Here's a link to the page where you can download the manual. Look at the left of the page under downloads, and you'll see the manual for your amp.

http://www.markbass.it/products.php?...&cat=3&vedi=39

osuok88 · #6 09-23-2010, 06:11 AM

Yes I got the download manual. Thanks a lot