Peavey IPR 1600 good for Pearce BC1?
Trying to find a good power amp to match up for my Pearce.
I'm painfully ignorant when it comes to this kind of stuff.
I've been using a SVT 4 Pro to power the Pearce last few years but I've recently freed up some more space in my rack and can fit a 2 space power amp. I use a Ampeg 8x10 and a 4x10 for smaller shows. Will this power amp be comparable to what a SVT-4 Pro puts out? I mono bridge the 4 Pro for the 8x10 and use half the amp when I use the 4x10.
Heres some info on the Pearce if it helps at all.
I'm sure it would work well but the IPR 1600 is out of production. Closest in production is the IPR2 2000.
PM BbbyBld to find out if it will bridge outputs.
I was going to keep an eye out for a used 1600 but I'II check out the IRP2 2000 aswell.
I have two IPR 1600s in my standard PA rack. One drives 8 ohm stereo mains, the second 4 ohm subs and 2 ohm total in monitors. They have been clean, rock solid and LOUD.
IPR1600 can do 1600W @ 4Ohm in bridged mode. Bridging is possible with a special cable that you'd have to make yourself.
I use one IPR1600 to drive my two fEARful cubes. it's a superlight amp and has enough power for me - more than I'd ever need
I use an IPR1600 with my Aguilar Tone Hammer DI and Eden WTDI. Plenty of power for what I do, sounds great, lightweight, simple setup, and inexpensive. All good, IMO!
I have one, coupled with a Parsek preamp... works great but I'd try to get a preamp with a strong/adjustable output, just to be sure it gives enough signal to the amp.
Also remember that Peavey and Crest warranties only apply to the original owner.
IMO, it is pointless to save a few bucks on a pricey used amp, instead of a new one with the warranty.
You would have to get an original IPR1600 very cheap to make it worthwhile.
My Crest ProLite2 was $325 shipped as a "demo", and still came with the five year warranty.
|All times are GMT -6. The time now is 07:04 PM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.