quick tech question

[loner9]

Plz correct me if i'm wrong here.

I have a little mark 800.
800 at 4 ohm, 500 at 8 ohm.

It has two speaker outputs.

If I hook up a single 8 ohm cab from 1 output, it would put 500w into it.

If I use 1 output to a single 8 ohm cab, and the other output to another 8 ohm cab, the total load is 4 ohms, each cab is gettin 400w (half of 800), and this is a parallel connection?

Is that the correct way to hook up my two 8 ohm cabs? Is any of that wrong?

Thanks in advance.

[brendanbassist]

Sounds correct.

[dmusic148]

You have it all exactly right.

[will33]

Yeah, that's right. Running two cords out of the head, one to each cab, or running one cord from the head to the first cab, then a second cord from the first cab to the second one will give you the same 4 ohms either way.

You could also run the head to a single 4 ohm cab, but then you're at your limit. Can't add a second cab to that.

[bassgod0dmw]

Yes sir. Exactly right.