Svt III help
 

I recently bought a used svt 3 got a good deal 350 and its an 06 model, im getting some static when i turn up or down the tube gain, i put three new sov-tecs in the pre still, static through my cabs. Has anyone ran into this prob, thought i mite clean the pots, but i wanted to get some feed back first thanks in advance for the help

If it is only when turning the pot then proper clean and lube should take care of it, If not you could have other (still not serious) troubles.

Thanks bstring i was really hoping it wasnt a mosfet science he sold it so cheap, when i turn the knob it takes a second then i hear a little static, could i be turning it to quickly, i herd it controls the power to the au and ax section,after the pre

Can't turn it too quickly. Does the noise stop?

I kinda thought so on the turning the pot, im surging to much power to quick, ill still deoxit and see where im at from that point thanks for the help bstring

Sorry if what I tried to say confused you. The speed at which you move the pot should not matter. Electrons move a lot faster than you ever could :). Crackling is "usually" a bad resistor and could be affected by quick changes be it from a control or voltage changes from signal applied (cold solder joints are also possible).

Jerrold Tiers will be by at some point and jump all over whatever I may have stated incorrectly :)

Kool thanks man