What amp do you use with your Genz Benz NEOX 212T

HMZ · #1 07-10-2011, 02:33 PM

What Amp and bass do you use with your Genz Benz NEOX 212T? I use a Markbass Little Mark II with my Fender MIA Jazz and P bass. My Jazz has been seeing more gigs this summer but i love my P bass as well.

Ozonbass · #2 07-10-2011, 02:39 PM

I use an old GBE-600 sometimes, but usually a Little Mark-II. I'm in the less-to-schlep camp. Off in 30 to play an outside gig today....only 150 fricking degrees...screw the country club dress code, I'm going commando.

KsPiNeSh · #3 07-10-2011, 03:10 PM

Warwick Streamer Stage II/Spector NS-5XL/Spector NS-5H2 into a Genz GBE 1200/ Genz Streamliner 900/Mesa M9 Carbine.

Edword · #4 07-10-2011, 03:55 PM

I use a G-B Shuttlemax 12.0 or Traynor YBA-3 with two NEOX212Ts.

**jmattbassplaya** · #5 07-10-2011, 04:28 PM

I use my Ampeg SVT or my Markbass LMIII through that cab. Both sound amazing through this amp, but the SVT really does take the cake. It sounds amazing in a mix. I play a Fender P, J, and EBMM StingRay.

packhowitzer · #6 07-10-2011, 04:55 PM

I have two neox 212Ts. I use an ampeg svt4pro (with a sansamp rbi). I usually only take one cab for gigs, but if I'm outdoors or without PA support, I'll bring both. Being that they're 4ohms, if I use both I run one out of each side of the 4pro. No bridging for those cabs. It is a nice setup for me.

**jmattbassplaya** · #7 07-10-2011, 05:25 PM

Quote:

Originally Posted by packhowitzer

I have two neox 212Ts. I use an ampeg svt4pro (with a sansamp rbi). I usually only take one cab for gigs, but if I'm outdoors or without PA support, I'll bring both. Being that they're 4ohms, if I use both I run one out of each side of the 4pro. No bridging for those cabs. It is a nice setup for me.

I've considered picking up a second one of those bad boys. Honestly, I can't think of a time when I'd ever need two of them because one of them is loud enough on its own, but it'd be kinda cool looking on stage

HMZ · #8 07-10-2011, 06:43 PM

Quote:

Originally Posted by jmattbassplaya

I use my Ampeg SVT or my Markbass LMIII through that cab. Both sound amazing through this amp, but the SVT really does take the cake. It sounds amazing in a mix. I play a Fender P, J, and EBMM StingRay.

I would love to try an Ampeg SVT with this cab. I bet it does sound amazing!

ErnieD · #9 07-10-2011, 10:01 PM

I've used both of them stacked vertically and yeah it does look kinda cool. Used them both with pre/pwer amp rig or my 2 ohm modded, NeoPak amp. I also use a 212T and a 112T for a shorter, 3x12" cool stack.

I still own and use the above amps also, LMII, F1 and most recently GB Streamliner 900 with my single Neox 212T cab. Using mostly, '08 Am St P5 w/flats or 55-02D w/DR BB's. And I use that low B string quite abit. All those heads sound good thru the 212T cab(s).

Very portable and powerful rig setup. And I get no PA support in 4 different bands. So I put it thru its paces alright.

CElton · #10 07-11-2011, 06:00 AM

I use a Shuttle 9.0. The pairing is ridiculously good. I've also used a Mesa M6 and it sounded wonderful also. The NeoX 212 is a great cab.

pbass62 · #11 07-17-2011, 10:43 PM

+1 on the neox 2-12 that cab has serious sound, love it, I am pushing it with the GB Neopak

FuzzBoxVoodoo · #12 07-18-2011, 05:59 AM

The Best cab I own for sure,I power it with a Aguilar TH500 or a Trace Elliot V-Type preamp/Carvin DCM2000L and it sounds great with 4 or 5 string.
It will carry it without PA support but then it gets to loud on stage.

garak7 · #13 07-18-2011, 06:42 AM

Shuttle 9.0. I also have the 6.0 and they both sound great through that cab. I too, was thinking about getting another NeoX 212T just for kicks so each amp could have its own!

packhowitzer · #14 07-18-2011, 06:53 AM

I have 2 NeoX 212T cabs. Usually one is enough for most of the club gigs I play. For outdoor gigs or where there is no PA support, I bring both. I use an ampeg svt4 pro in dual mono when i use both cabs. Since they are 4ohm cabs, I can't bridge them as the svt won't support a 2ohm load. I also use a sansamp RBI at all times with the svt4. I would love to try them through the new GK MB800, but I am a penniless beggar right now.

Bassguy1 · #15 07-18-2011, 07:01 AM

STL 600...perfect match IMO. I switch between my Pat Wilkins Custom P bass (3TS) with Fender roundwounds or my Pat Wilkins Custom P/J (Shoreline Gold) with TI flats.

lomo · #16 07-18-2011, 07:49 AM

[quote=ErnieD;11165267I also use a 212T and a 112T for a shorter, 3x12" cool stack.

:[/QUOTE]

I'm gonna try this with my Walkabout and M9 next week. I'm itching to have a go at the 212-the form factor and wheels alone make it a must try for me, and the vertical array seals it.

fishtx · #17 07-18-2011, 08:08 AM

GBE 1200 or GB ShuttleMax 9.2...