Does round core, hexagonal core effect tension?
A few months ago, I set up my Jazz bass with 50 - 110 DR Low Rider strings, mostly because that's what the local store had available. I would like to use some DR Hi Beams with a round core instead. I have slightly more string height than I'd like, & I think using 45 - 105 will make it about perfect.
However, will changing from a hex to round core additionally effect tension noticeably enough to cause the bass to fret out with the lighter strings? I know there's a noticeable difference on my guitars when switching from round to hex core.
Just looking for some input before I order the strings later tonight.
BTW I'm a new member. I've been lurking for a few weeks & I love the forum. :bassist:
You don't change strings to change neck relief. Basses have truss rods for that.
The tension required to tune a string to pitch (same gauge) will be close.
Often, 'Flexibility' is confused with tension and usually round-core strings feel more flexible than hex-core strings and have greater excursion while playing, same as lighter gauge strings tuned to the same pitch (w/less tension). This may require a small string height or even a minor trussrod adjustment.
The hi-beams are likely to hit the frets if your action was right before. If your action was a bit too high in the first place they might be fine.
This doesn't even have to do with how the string pull on the neck, just how they swing for the same resulting frequency. Whether they pull more or less for neck bow is a different matter.
The string height is great @ the 1st & 20th fret, but slightly higher around the 7th, 8th. I think a slightly lighter gauge will make it perfect. I ultimately rather have the 45 - 105's.
I just wasn't sure if the round core strings would additionally effect the tension.
|All times are GMT -6. The time now is 12:33 AM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.