Anything Eden Thread

[Michael777]

A spot for all things Eden

[snowbird]

I have a WT550 amp and a D210XST(4 ohm) and am considering adding a D210XLT. The only issue is that the local store has only an 8 ohm model in stock. Do you see any problems in conbining them for an impedance of 2.67 ohms? And what's your take on putting the XST on top and the XLT on the bottom. Or might I be better to consider a different cab to partner with the XST? I just love the Eden sound and feel that I would like the XST to sound a little dominant in an XST/XLT combination. Thanks!

snowbird
Chris

[Michael777]

Originally Posted by snowbird

I have a WT550 amp and a D210XST(4 ohm) and am considering adding a D210XLT. The only issue is that the local store has only an 8 ohm model in stock. Do you see any problems in conbining them for an impedance of 2.67 ohms? And what's your take on putting the XST on top and the XLT on the bottom. Or might I be better to consider a different cab to partner with the XST? I just love the Eden sound and feel that I would like the XST to sound a little dominant in an XST/XLT combination. Thanks!

snowbird
Chris

Hey Chris, as far as the 2 Ohm thing goes It is not a problem to run the WT550 at that Ohm rating. However make sure you have good ventilation all the way around the head as it will cause it to work a slight bit harder......Since the Xst is Slightly Different in Frequency Response, I think it will Pair fine and Even Add a Little Depth in the lower Frequencies!!!! I would Actually put the XST on the Bottom, If it were me.

[snowbird]

Mike--Thanks very much for the info. I appreciate your getting back so quickly. Will keep things very well ventilated.

snowbird
Chris

[lowb1970]

Eden cabs rock! I replaced a 4x10 cab with a 2x10 XLT and plan to get either a 2x12 or another 2x10 to complete the speaker portion of my rig. These cabs just sound incredible. You know I'll be in to BC to get it too.