a few touches
so i got a hard ash stingray body copy from the net and got me thinking it weighs a bit to much, my back can handle it but i find it easier to play a lighter bass than a heavier one, still it doesn't compare with the playability of my feather lightweight alder jazz
not that it's unmanageable but i think i can slim it a bit by sanding on the area where you lay your arm on the body, i can't recal what that area is called, also the place where the bass makes contact with the stomach, that as well i can't recall the exact name of the body feature
so the body didn't come with those areas preshaped but it'd like to do it myself with some heavy/light sanding and then refinishing the area without repainting it so the natural wood is exposed and it would also give the bass a relic-ish feel (dunno if there is such a thing as relicd ray)
i'm going to install a obp1 pre in the near future so i'd like to route some more space underneath the pickguard as well to fit the pre
any tips to get rid of the extra weight are greately appreciated
oh and btw, is there a way to replace caps on a stingray control plate? i would need to do it to fit 500k for the obp1 pre
the knobs dont have any screw on them to take them off..
It'll look like crapola if you don't get a full refinish when you cut the contours. And it really doesn't save that much weight unless you make them really deep. Try a wider strap to spread the weight around a little bit.
And for the electronics, all of the existing stuff would be replaced with the new pre-amp. And no offense, but if you don't know how to even remove the knobs that don't have set screws, you should probably take the bass in to a tech to get the work done, or just leave it stock. What are you hoping to get out of the new pre amp anyways?
i recently got in posession of a modulus flea pup and i wsnt to couple it with the obp1 to get that modulus growl the "ghetto way" since i dont wanna go through the hussle of saving for one, i'm currenly saving for a wal already
so when i got the pup i thought why not get a nice stingray body honey burst and slam a nice slim maple jazz neck on it and get the best of all worlds?
and so that's what i'm doing, but i'd like to know how can i safely remove the caps from the control plate so i can install the 500k's the obp1 comes with
and what could i do to further reduce the weight of the heavy ash body
|All times are GMT -6. The time now is 05:33 PM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.