Fixing an Ibanez Case
I recently purchased a brand-new Ibanez hard case for my Gary Willis bass. I was loading it in my vehicle after a gig it was 0° outside and I banged it on the door frame. Cracked the case the first time I used it.
Any ideas on how to fix this?
Granted, all the Ibanez cases I have repaired have been older ones, but on those the material has been easily weldable.
I've used epoxy and bumper patch. Both seem to hold up pretty well.
I wondered if I should drill a small hole at the ends of the cracks to stop them from running.
I wondered about plastic welding? This case looks like ABS, but I am. Not sure.
What is bumper patch?
I gave heard about plastic welding. Isn't it kind of like brazing except with plastic? Where do you get the "welding rod"?
Apologies for not replying earlier, I've been on a mobile device and except for one-liners, I HATE typing with a touch-pad.
The technique -prep and bead forming- can be pretty much the same as well, just the temperature is lower.
If the innards of the case can't be removed, I've used a specially ground soldering iron tip, the somewhat uncontrollable penetration control of a hot air welder may melt the (styro-) foam material inside the shell.
I have used strips cut from pieces of smashed cases with great success, but any modern auto body shop should carry ABS filler rod as well.
They weld dashboards and bumper outer shells daily.
In a recent thread about the same subject, someone pointed out MC shops as candidates for filler material as well.
Some hardware stores may carry hard plastic filler rods, but usually their products are for welding plastic floor materials.
Found out that this case is Polyethylene instead of ABS.
What is an MC shop?
Search 'polyethylene welding' (used 'ZOO').
Lots of info on welding it, including supplies.
Been welding motorcycle (dirt bike) fenders, batteries, etc with a cleaned soldering iron tip for 40+ yrs.
Sorta like gas welding/brazing, with no torch.
Use good ventilation.
|All times are GMT -6. The time now is 08:31 AM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.