My Corvette fell on the just-a-nut!

The Artist · #1 03-09-2010, 06:04 PM

Just before practice yesterday, my bass toped over and seems to have landed on the just-a-nut. The ajustable screw for the lower strings was pushed into the nut and I can't screw it anymore. I ordered a Just-A-Nut III but becouse that was all they had. I am not sure which just-a-nut I had. It was a Corvette $$ from 07. I am guessing the Just-a-nut III will be compatible even if I had the Just-A-Nut II wouldn't it?
Cheers

**lowendfriend** · #2 03-09-2010, 07:43 PM

You want the JAN III....that's what I have on a 2006 Corvette $$...it came stock

grifff · #3 03-09-2010, 07:47 PM

Yup all the JAN's are interchangeable. You could have even put a JAN I on your bass.

The Artist · #4 03-10-2010, 04:10 AM

Even if i just replace the adjustable part? (leaving the glued on bit where it is)

quigg · #5 03-10-2010, 04:15 AM

I replaced the JAN on my Infinity, but I took the bottom part off with a razor, it just popped right off.

The Artist · #6 03-10-2010, 04:17 AM

ah...but if it came with the the JANIII it'll be no problem. Oh I hope it gets here bofore practice today

coreyfyfe · #7 03-10-2010, 04:18 AM

Quote:

Originally Posted by The Artist

Even if i just replace the adjustable part? (leaving the glued on bit where it is)

IIRC you have to remove the base of the JAN II before you put on the JAN III if that is indeed what you have. That's what I had to do on my 2003 thumb, but I'm not certain when the JAN III change over was.

The Artist · #8 03-10-2010, 04:52 AM

If I am not mistaken and the just-a-nut II only had counter holes for the ajusting screws and the Just-a-nut III is the one with with the holes and two pins (which is what I had), I'm good to go without having to sand or glue anything