Replacing bridge with quick load
I have a short scale p bass which is becoming my travel bass.
I am adding neck studs (stainless steel) so I can remove the neck often to throw it in my luggage (only option).
However, I would like to replace the current bridge with one that has quick load string option, so I can remove the neck just by loosening the strings, and not have to remove them.
This is the current bridge:
I canīt find a bridge that has the same screw spacing, but is quick load.
Can I just fill the holes with wood filler, and then re-drill, or is that a bad idea?
Thanks in advance!
Bad idea. Wood filler has no strength. Get some hardwood dowel and fill with that.
So I just find dowel of the right size and glue this in place with wood glue? What about filling in around the dowel, I guess this will not be seen, but is this needed?
Why not just use a Dremel cutting wheel to cut slots fr0m the top of the bridge down to the string holes so you can top-load the bridge you have now? Make the cuts at an angle and hit the hole near the bottom of the hole so the strings can't walk out.
Or: remove bridge, drill out holes to specific plug dimensions, get plugs to fit, score grooves down each side of each plug to allow glue to exit, add Titebond glue, press plugs into holes, wipe off excess glue, let glue set, cut off excess plug material, re-mount bridge.
Personally, I'd spend more time looking for a top-load bridge that matched the screw holes.
I did think about the cutting route, but would this not affect the strength of the bridge?
I have been looking for bridges with the same string spacing, but it seems that the quick load bridges seem to have the screws centered below the strings, where as the on I have a located between the strings.
(Also, I do not want to spend too much on a bridge for this cheap bass, it is only to throw in my luggage for travel)
|All times are GMT -6. The time now is 06:18 PM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.