SX replacement neck

TJBass · #1 02-12-2008, 10:14 PM

I'm thinking of scrapping my SX jazz fretless 5 string neck for a fretted 5 string neck on the rondo website.

Theres nothing wrong with my fretless neck, I just give up trying to play a fretless bass.

Has anyone had any problems fitting the replacement SX neck to the body? Is it pre-drilled for an SX body?

Thanx

Dirty Chris · #2 02-13-2008, 03:05 PM

I haven't been in your exact position, but I recently ordered an SX neck (4 string "vintage" Jazz) for a project bass and there are no holes pre-drilled. I was, however, very pleased with the product's quality.

TJBass · #3 02-13-2008, 05:46 PM

How did you mark the location of the holes to drill into the back of the neck?

robert43 · #4 02-14-2008, 04:54 AM

Just fit your new neck to the body long drill bit drill thorough the body holes , then take apart & drill.
Or get your screws start the screw it will put a dint in the neck take apart & drill.
I found it easiy to mark & screw 2 scews diaganally the check if ok the do the other 2 if not adjust

TJBass · #5 02-14-2008, 07:29 AM

Duh....I knew that....I don't know what I was thinking when I asked that question!

Thanks for reminding me!