Where can I get a custom control plate made ?

[4Mal]

I'm thinking about re-vamping the electrics in a rear route bass. If I go through with it, I'll need a custom plate for the front.

There are two existing holes and the spaceing / placement / size of the cavity lends me to think that mounting something about hte size - but not the shape of the J plate - maybe ovalized - would make sense.

I've also been contemplating re-doing the pre in a 2 band Ray SUB - anyone got a source for an EB MM control plate ? I'm thinking about a 4 band Audere ... I would prefer a 5 knob setup - in a pinch I could go 4 knobs and a side mount jack...drill a small hole for the z-mode switch. It would be nice to be able to go back though ...

[LzeroKI]

It would seem to me like your best bet would be a machinist or small machine shop.

[mjolnir]

This place can probably hook you up:

http://www.sharp-concepts.com/store.htm