Tell me how to

[Honk'n_down-low]

I want to do something simple with my Rig - hoping someone here in the recording section can help me architect this.

I want to be able to use two primary Basses, switch between them seamlessly with my output going to one of two different Amps and then out to the same set of cabs.

In effect - I want to be able to use either Bass - driving either Amp - with the same set of cabs. In this case I don't care if I can run both Amps in Parallel - I just want each Bass to able to take either path - that is Bass1 > Amp1 > Cabs or Bass 1 > Amp 2 > Cabs. And the same option with Bass 2. Got it?

Looking at the Radial stuff and thinking through some combination of their ABY pedal and another device I might be able to pull this off. What say you? Thanks in advance.

[Honk'n_down-low]

Anyone? I guess I am pioneering new territory here?

[J. Crawford]

Honk'n, if you dropped this in a different section it would get a lot more attention.

[Honk'n_down-low]

Where would you suggest - not sure where this topic should go - obvious to me Recording was not the best choice.

Effects maybe? Mods please move if there is a better location - thanks!