Any Crest CA Series Gurus?!?

Zooberwerx · #1 03-04-2011, 09:47 AM

I have a CA-6 with a couple of "mashed in" indicator LED's. I need to know the correct procedure for removing the attenuator board (located directly behind the chassis' front) from its 4 stand-offs so as to fully access the bulb limbs.

Promise not to electrocute myself!

Thanks

Riis

Robal · #2 03-23-2011, 08:40 AM

Quote:

Originally Posted by Zooberwerx

I have a CA-6 with a couple of "mashed in" indicator LED's. I need to know the correct procedure for removing the attenuator board (located directly behind the chassis' front) from its 4 stand-offs so as to fully access the bulb limbs.

Promise not to electrocute myself!

Thanks

Riis

I called Crest when I had a question about damage to my CA9 and they were very helpful over the phone. Why not go to the source?

Zooberwerx · #3 03-23-2011, 11:32 AM

Quote:

Originally Posted by Robal

I called Crest when I had a question about damage to my CA9 and they were very helpful over the phone. Why not go to the source?

Done deal. I received a response the other day. Seems the attenuator board stand-off mounting screws are located behind the front panel decal. I can either remove the entire decal or razor out the critical areas with an Xacto knife. Not necessarily convenient but it resolves the mystery!

Riis