Mixwizard Question

[Laserman]

I have an Allen & Heath 16 channel Mix Wizard. Currently the Input and output Jacks Panel is in the Table Top position it comes in right out of the Box. I know you change the Panel position for rack mounting. I was wondering IF I can get the Panel to lay out Flat ( Horizontal) so I can use a Mixer case I already Have? Any ideas? If yes, how do you do this?

Thanks

[jimmy.timms]

If you look on the sides near the hinge assembly you will see a screw on each side. Remove these screws and the I/O section will pivot. Put the screws back in where they align now to give you stability. I hope this helps.