x2 wireless power supply

soleil4716 · #1 09-19-2010, 10:58 PM

I have the Line 6 x2 wireless system. I am checking to see if I can use a regular 9V power supply for the receiver unit. I think the recommended power supply is 9V 100mA. Will it be risky to use 9V 250mA supply with it? Should it not just draw the amount of current it needs from the 250mA that is available?

Thanks.

buddingbassit · #2 09-20-2010, 12:47 AM

from what i know you can use it. they will draw only as many amps, (milliamps in your case) as they need. i used a 500mA with my shure radio receiver with no problems i did find the sure power pack the next day though

just make sure the + and - are correct.

pbass62 · #3 09-20-2010, 06:35 AM

I used to have the same system. You will be fine with that power supply as long as your adaptors polarity is correct.

soleil4716 · #4 09-20-2010, 07:22 AM

I am thinking about using Gator's G-BUS-8 power supply. It seems to have matching polarity (negative tip and positive outer).

This power supply comes with Gator's pedal board. I also have a Korg Pitchblack tuner. Just planning to put everything on the same board to simplify power management and transportation

Thanks for the replies!