Peavey 696F PA

Nickthebassist · #1 03-25-2005, 08:56 AM

Ok, we just got the right fuses for this after one mysteriously blew up. SO now it works. The only problem is we don't have the correct speaker cables yet(we have them ordered, just waiting). So, i was wondering if it's ok to run it without hte speakers, but send a signal to the powered monitors via the monitor line outs? It's solid state i think, so is it ok to run it with no load?

Selta · #2 03-25-2005, 09:22 AM

Quote:

Originally Posted by Nickthebassist

Ok, we just got the right fuses for this after one mysteriously blew up. SO now it works. The only problem is we don't have the correct speaker cables yet(we have them ordered, just waiting). So, i was wondering if it's ok to run it without hte speakers, but send a signal to the powered monitors via the monitor line outs? It's solid state i think, so is it ok to run it with no load?

Ask Peavey, they have great C.S. and will get you an answer within 24 hours usually. If I had to take a crack at it I'd say you'd be 100% safe running it with no load.

Ray

Petebass · #3 03-26-2005, 12:09 AM

Quote:

Originally Posted by Nickthebassist

Ok, we just got the right fuses for this after one mysteriously blew up. SO now it works. The only problem is we don't have the correct speaker cables yet(we have them ordered, just waiting). So, i was wondering if it's ok to run it without hte speakers, but send a signal to the powered monitors via the monitor line outs? It's solid state i think, so is it ok to run it with no load?

If it's solid state there should be no problem running with no load.

Seeing this is a PA question more then a recording equipment question, I'll move this to Misc.