**Line 6 POD XT LIVE ****Help**** Please

[JonathanD]

Alright.
So my problem is that I get really low output from my unit.
There is no way I can run it into a power amp with out another pre because it is so quiet. When I change the switch in back from LINE ---to AMP it gets quieter. Is this supposed to happen?

I sent it back once because the volume kept dying on me after 30 seconds. Now I think it just doesn't put out what it should.

I have all the setting from the manual right, adn I ahve tried all the output setting I can. its not the pedal and I ahve to turn each channel volume up all the way just to hear it. I can run it into my eden 550 AUX IN and turn the master all the way up and its not above speaking level.

I have to turn the pad off and run it through the front and turn the gain all the way up, and I still am not hitting the compressor.
Jonathan

[greenboy]

Probably wouldn't hurt to check around in the effects section.

[JonathanD]

Everything is off, no gate, no effects, no compressor, and even when I turn the amp section off and bypass everything its still not loud.

I added a True bypass effects loop switcher in front if it and I have found that if I turn up everything on a preset amp section and leave everything else off I ca get to about the same volume as my bass alone puts out. But if I don't crank the gain and EQ and only crank the Volume it is only about 1/2 as much signal as my bass alone.

Jonathan

[greenboy]

The EFFECTS section below the AMPS section here on talkbass, I mean ; }

[JonathanD]

Just tried the DI out and it is about 10dB louder than the bypassed signal straight from my bass. (I am checking using Logic Pro on my computer.)

Jonathan

[JonathanD]

DERRRR I am smart at tater tots.
Thanks,
Jonathan