| AMT Bass guitar preamp "BASS CRUNCH BC-1"
Sign in to disble this ad
Hello people,
I hope I've placed my topic in the right section of this forum. I'd like to tell you about the new device by AMT Electronics.
AMT «Bass Crunch» BC-1 JFET Bass guitar preamp
АМТ Electronics is proud to present its new product – AMT «Bass crunch» BC-1 2-channel bass guitar preamp.
This preamp is built using АМТ’s unique technology – JFET emulation of vacuum tube clipping. Wide adjustment range and rich functionality (especially for a floor device) make the presented preamp extremely versatile.
«Bass crunch» BC-1 preamp is built on two-channel circuit.
CLEAN channel produces classic bass guitar sound one can hear from classic tube amplifiers. You can get both warm transparent sound and compressed slight overdrive, depending on position of the Gain knob.
DRIVE channel contains a number of overdrive stages and is designed for modern sound – from clean to severely overdriven. High mode provides additional possibilities to enrich the sound spectrum and produce even more thick and aggressive sound. Adjustable 3-position mid-range filter, along with wide high and low end adjustments, offers rich tone shaping possibilities and let the player create unique overdrive tone.
Controls:
Clean
LEVEL – output signal level adjustment
HIGH – high frequency adjustment
MID – middle frequency adjustment
LOW – low frequency adjustment
GAIN – channel sensitivity adjustment
Drive
LEVEL – output signal level adjustment
HIGH – high frequency adjustment
MID – middle frequency adjustment (set by Notch Freq. switch)
NOTCH FREQ. – cutout frequency switch (rejection filter) 500Hz, 330Hz, 230Hz.
LOW – low frequency adjustment
PRE. NOTCH – rejection filter switch before Drive stage. 700Hz, 400Hz.
GAIN – channel sensitivity adjustment
General Controls
BLEND – balance between Clean and Drive channels
MASTER VOLUME – BC-1’s overall output level adjustment
DRIVE – Drive channel on/off footswitch
LED – Drive channel on indicator
HI/LO– high/low sensitivity of Drive channel footswitch
HI/LO LED –high/low sensitivity of Drive channel indicator
Connections
Right Panel
INPUT – instrument input
SEND FX – signal send to aux effect
RETURN FX – aux effect signal return
Left Panel
OUTPUT – direct output to power amp.
CTRL OUT – AMT TS-2MIDI aux converters control output
CAB.SIM. – direct output to mixer’s line input.
DI OUT – balanced output for connecting devices with balanced inputs.
Power
DC 18V – for power adapter connection
Battery compartment – for two 9V batteries installation.
May 28, 2010
Last edited by Maser : 06-04-2010 at 05:23 AM.
| 
