Need a hand with my pedal chain!
 

Hello guys, I have a few effects, and I want to make low noise pedal chain.
So let’s cut to the chase this are my pedals:

1)Sansamp para driver DI
2)Mxr Bass envelope filter
3)Boss Bass Overdrive
4)Boss Bass Chorus
5)MXR micro amp


that’s how I use them, the bass goes directly to the number 1, and from the number five I plug to the amp.

Any suggestions??

I put my DI at the end for tone shaping and so I can send a signal to the board with my effects in it. The others are probably how I would do it I guess.

There's no right answer, but if those were mine, I'd go 3, 2, 5, 4, 1.
Reason, I like dirt before filter, and DI should always be last.
Where's the tuner?

I dont have a pedal tunner! =(, I always tune before playing, But I'm planning to buy a pedal tunner

I second this statement. Only thing I may do different is put the Chorus after the DI if I was using it for heavy distortion.

I used the DI for tone shaping because of the crappy amps that I usually play in the differents pubs with my band, I don't use it like a heavy distortion.

Forgot to tell you that I play a active bass (mm stingray)

http://www.gmarts.org/index.php?go=222

some pedals Don't play nice with others in certain order...but generally there is not right or wrong way

I'd spend hours playing with the order, but I'd probably start with this and see where I'd take me.

BASS > BEF > micro amp > OD > Boss Bass Chorus > Sansamp para driver DI > AMP