Need some help trying to make this...

[isher1992]

Hi, guys. I've got some jacks lying around and could use some advice on what to do here, because Google is yielding unsatisfying results.

I'm trying to fab up a signal splitter that can take an unbalanced mono signal and split it two ways that are also mono unbalanced outputs (as even as possible). I have 3 mono jacks and three stereo jacks and an enclosure. I'm hoping to just make a passive splitter. Any advice or wiring diagrams to show me what to do would help greatly. I just want a basic little splitter box that takes my effects chain and splits off to a separate board, and to a DI box. I can draw it up if needed.

[krstko]

just take one cable and make it jack-jack ..than cut it a bit somewhere and add another cable

[isher1992]

I don't really have any cable to cut up... Really was hoping to make a small little box to do it.

[krstko]

you will need cable, maybe just 10cm of it, but you will need it

[Skrogh]

1. Connect all grounds together.
2. Connect all "hot" - maybe you want to put two resistors in between the input and the two outputs.
3. Put the jacks in a box.
4. Done.

Tell me if you need a pic