pedal board woes

[Hutzbordello]

so right now my "board" consists of a fuzz factory, a vt bass, and a wounded paw fx loop.

i hope to be adding a dod-250 for just dirt as opposed to wild fuzz all the time as my only distortion pedal and a weeping demon wah.

ive been trying to configure a way to run the pedals in an order so they all are used with the vt, but theres a two channels in the fx looper. and im not even sure how much tone suck to accomodate for.

without having everything in front of me its jut homework to figure it out beforehand, but if anyone has some info on this itd help.

so basically im wondering how to set my board up so everything is run through the vt which would mean 4 pedals in the wet signal and non in the clean via the blender v2.

and how much tone suck you could guess id have with all of these. thanks

esp ex 104 throgh a gk mb 210 and a mbe 410

[cheapbasslovin]

Put the VT between the output of the blender and your amp. Then you can fill your loops in whatever configuration you like and they will all be injected with VT goodness..

It is unlikely that two pedals with half decent bypass design will cause noticeable tone suck.

[Hutzbordello]

ah thanks man you saved me