|DarkAscentBass ||01-18-2014 10:07 AM |
So I have an issue....
In my band I run a darkglass b7k for my dirty sound but I have several songs I need a good clean signal. So here is my problem I want my clean volume to match my dirty volume. I am using a boost following my compressor right now to somewhat achieve my goal. It's still not quite what I want. So I was thinking of buying another preamp type of pedal and a ab switch to run two different chains I guess.(sorry new to pedals and effects my jargon is not up to standards.). Is this the best way or is there a better way should I just leave add the second pre amp in line with out an ab switch. What's your suggestion.
|bassgod0dmw ||01-18-2014 01:58 PM |
Why are you not matching both to begin with? Use the clean signal at the volume you want, then turn on the B7K and adjust it's volume until both levels are matched. Toggle back and fourth between both of them until it's the same.
|All times are GMT -6. The time now is 05:21 AM. || |
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.