will this work? A/B/Y pedal

[strke-fender]

hi everybody,

I'm looking for a cheap way to keep my non true bypass tuner out of my signal chain with out running a chord to the tuner out of my amp. (its just annoying)

so I'd like to run my signal through this and my tuner and be able to the tuner to tune in silence without the tuner being in the signal.

is this what i need?

thanks in advance.


http://www.ehx.com/products/switchblade

[Bassenstien]

Should work fine.
When I was looking at ABY's though I found that some will give some graound hum. This shouldn't though.

[Sean S]

That would work. If you're just doing A/B (silent tuning) pretty much any passive A/B pedal will do.

[synterx]

The Radial one was the best I had. I tried the all. No ground noise at all with the switch it had to kill it. Solid as a rock, small, and very nicely made. Cheap too. Honestly though, I could never tell the difference sonically with just going through the tuner and being done with it. On paper it seems like you shouldn't but will anyone notice?