Did you ever find parts that work? I am looking for pots for my Seymour Duncan preamp. I ended up getting the Fender part 005-6160-000 from basspartsresource.
The only issue is that the solid shaft is too short and narrow for attaching my set screw knobs. When I tighten the set screw, it ends up slightly tilting the knobs enough so that one area at the bottom edge of the knob rubs against the nut used to mount the pot as the knob is turned. I'm not sure if there is a specific type of knob that is supposed to work with these pots.
At one point I had put some pots in my bass that I got from China on ebay, but one of the three pots ended up not working, plus there was no center detent to feel when my EQ controls were zeroed, which is why I eventually went with those Fender pots.
Black 'n Maple #518 / Music Man Stingray #517 / Praise & Worship #1299
Last edited by poit57 : 01-24-2014 at 09:44 AM.