I thought I found what I was looking for but I still need help. I have a 3 pole/3 position rotary switch. I marked w/dots where the stops are. (1 dot/2 dots/3 dots - 3 locations) I'm going to assume that the center poles align w/the set between 1/2 for each. Maybe that's not true, so correct me if I'm wrong.
I want to wire it for 2 (passive) pu's, N/N&B/B - a basic set-up. I'm not versed in reading technical drawings so would need pretty simple wire A goes from here to here, or a simple sketch.
Before posting this I searched extensively for a tutorial or schematic that would answer my question but I just can't find anything. It's not even that tricky - just 3 positions.
I found this EB-3 cavity shot but it's hard to determine exact configuration from it, otherwise it's basically what I'm after.
