Allparts Pots and Caps Question

[Funkflats11]

Hello,

I am planning on modding my 2004 Squier P-Bass with new Pots and Caps.

1) I am planning on putting .047 Orange Drop capacitors. I noticed on the allparts site there are mfd 600 volt and mfd 200 volt versions, which is the one that people use more. I am kinda confused by the voltage difference? Is there a noticeable difference between the two?

2) Again on allparts I am looking to replace my volume Pot and blend Pot with CTS Pots, what CTS pots has anyone used in their Squier P-bass? Did it fit initially or was dremeling required?

3) Lastly, any tips or links to how to replace pots and caps would be appreciated.

Thank you

[line6man]

For this application, voltage rating neither matters, nor makes any difference in tone.

The difference is that the 600V capacitors are designed to handle a greater voltage than the 200V capacitors.

Your bass is outputting a signal of a few hundred millivolts, to perhaps a few volts peak-to-peak at the maximum.

Any capacitor above say 5V should be fine.