Distillate Electronics Modifications
I removed the led light connection of my Alembic(it was making a little thud noise with the light flashing on and off), and had to make my own ground wire, which was a pin needle I stuck into the shielding paint that I had attached to a part of the input jack. It's been working for 3 months now, and my battery life improved 2 fold.
Will this have any long term effects/problems to my bass? I wouldn't be able to afford new stuff from their shop, and don't want any substitutes.
Did some reading on the subject. I think I did everything right, as far as removing the led connection..I just want to know if using the pin needle is ok.
bump for info
And no, the pin ground is not OK. It has a number of problems such as falling out and not making a good connection to the conductive paint over time that can occur.
The standard ground connection to shield paint is to get one of these:
It is a solder lug with a built-in lockwasher with "teeth". The teeth "bite" the paint making a good connection. You simply solder a wire to lug, the other end of which goes to the body of the output jack (ground). Then you take a wood screw of the right size and simply screw the lug down on the paint so the teeth bite into the paint. Done. Permenant good connection you won't have to worry about.
Thank you. I hope I didn't damage anything under the hood while doing all that with the pin. It made a loud pop through the amp(I might have read about that happening, and it being ok), and this flange-fizz sound, just before I got it working again, got it activated. Sounds pretty flippin' great now.
The problem with the pin, was I couldn't get it in the wood very well. lol That's some dense stuff! I need one of those lugs.
Rule. Transistors make better fuses than fuses.
|All times are GMT -6. The time now is 01:18 AM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.