Hartke HA1200 main board removal
My beloved Hartke Kickback 10 (120 RMS Watts) was in an accident and the mid control knob in the EQ section has been sheered off. The schematic shows It is a 50K (linear taper) potentiometer ( VR104 ). I have had training and experience with soldering, schematics and circuits in general. I use this little amp all the time and want to replace that pot. Looking at the amp assembly leads me to think removal of the main board where that pot is mounted will be very difficult to remove because the power transistors are mounted to a heatsink and there is no obvious clearance to remove the circuit board from the steel housing assembly. Has anyone removed this board in order to perform service? Any advice would be greatly appreciated. I do not want to pull it apart, only to cause more damage....thanks..Roy
|All times are GMT -6. The time now is 01:25 AM.|
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.