Originally Posted by bajerovaquero
Thanks for your responses! I appreciate
Here is the wiring diagram:
There are pots of 500 100 and 25k ....
I¨m going to wire first a 500k pot between hot and jack and listen what happens if not work then a 50K
Also I got some 250k dpdt pot so could you provide some schematic RobbieK?
The pickups are clearly stated to be active. This means you should use a 25k tone pot. (Or 50k, to taste.) Additionally, you may want to try higher capacitances than would typically be used for passive pickups, because the frequency cutoff point of a tone control is partly dependent on signal impedance. 0.1uF is a good place to start.
Note that tone controls behave a bit differently with buffered signals than when they are allowed to interact with the impedance of a coil.
For a tone control that is only in the circuit in passive mode, use this diagram: