So I spent a whole hour last night coming up with wiring mods for my Squier Mikey Way Mustang bass. The problem is that I have no experience with wiring whatsoever
. I need some instruction on how to go about doing these complex mods, if they're even possible to do.
What I came up with:
- EMG 35HZ humbucker
- 3-way Gibson-style switches where the knobs would normally be
- in tone knob position: switch down = rear coil, switch middle = full humbucker, switch up = front coil
- in volume knob position: switch down = series, switch mid = killswitch, switch up = parallel when in humbucker mode
- when pickup is split either way: switch down = unaffected, switch mid = killswitch, switch up = bass cut (like on the single-pickup VM Tele basses)
How would I go about doing this, with no wiring experience at all? Specific instruction is appreciated.