Vintage Fender Jazz knobs, in "stack knob"

[Chef]

I dunno if this is the best forum to ask this, but where can I get the Fender Jazz bakelite looking knobs, in a stack knob configuarion, like so...look at the lower most one, which is "bass and treble, stacked," in this case:



thanks for leads!

[4Mal]

My '06 Deluxe J has stacked B&T in bakelight. Buy me a full set of 'un-obtanium' plated bronze knurled knob's and they're your's (such a deal I got for you, just today !)

Or you could just call a Fender dealer and order them. Angela Instruments probably has them. When I order Fender parts - which I almost never do - I use these guys http://www.musiconeworkshop.com/ based on the picture some Good Fella's set up shop in Montana... Seriously good service from them the few times I've needed Fender parts. Small shop but they have a big, big following in the Tele 6 stringer community.

Nice lookin' bass by the way!

[bikeplate]

HI

Sadowsky puts them on some of their new basses. Id call or email them in NYC

Rob

[Chef]

That's a Valenti, as is the one the knobs are going on...they're not for this bass.

They're going on Geddy Vee #18, this'un:


Which came with an OBP3, was changed to Audere, and will soon have a Nord preamp
(vol/vol, passive tone/pull to activate, mid/pull to shift, bass/treb)

[RPIcka]

http://www.guitarpartsresource.com/g...obs_fender.htm

[Chef]

I looked for those in the bass parts resource section, thanks for that!

[Hambone]

I've never seen a stacked bakelite knob like that. I must be completely out of touch.

[Webtroll]

I just ordered a set, haven't installed them yet:

http://www.darrenriley.com/shop/cart..._detail&p=1091

Is this what you were looking for?

[Chef]

yessir, that's them
better price than basspartsresource too; thx!

[Chef]

update:
fwiw, nordstrand had some of these for their preamp...