I have a dual concentric pot control that is experiencing a smidge of strangeness. When I roll the volume all the way off, I am still getting about 10% of full volume.
Each of the pots is a stacked dual 500K control like this
I am utilizing this for a wiring configuration (the configuration is listed on the Fender site)
utilizing a multi-tester to check for resistance, I cannot find any place where I am getting a short or cross connection. with the volume rolled off, I get proper resistance across each tab. with the volume rolled on, I get proper resistance across each tab. The wiring is clean with no touching leads. I have no ground buzzes or crackling.
with the volumes off and plugged into an amp, I can tap on each pole piece and hear the click of my screwdriver touching the magnet
am I missing something here? I have not had this experience in the past
all the best,
R
