Finishes that show up the flames in maple

[giacomini]

OK, I looked this up but didn't find a specific thread...

I'm getting a new Jazz and I already got some beautiful flamed maple for the neck.

My question is, what kind of finish makes the flames more prominent (like those that look quite "3D")?

[Musiclogic]

The grain has to have the 3D look before finishing. If the quality of the figure doesn't have that look, you will have to settle for plain flame look. You can use a wash of light amber in lacquer thinner to make the figure pop a bit, then shoot your finish coats if leaving it natural.

[giacomini]

Originally Posted by Musiclogic

The grain has to have the 3D look before finishing. If the quality of the figure doesn't have that look, you will have to settle for plain flame look. You can use a wash of light amber in lacquer thinner to make the figure pop a bit, then shoot your finish coats if leaving it natural.

Well it looks 3D but the effect gets more prominent when I rub some alcohol, so I guess it will turn out good.

I plan to leave it natural, but does it need to be glossy to make the flames stand out a little more? Or will a satin clear finish work as well?

[ThaLowEndTheory]

I like to use tru oil on figured wood. I use it on just about every neck I have. Just rub in by hand until it builds. You can apply enough to polish out to a mirror shine, or leave it semi glossy or apply just enough for a satin look. Really pops the grain well. The wood itself makes or breaks the look in the end though. Here's a couple of bodies I used tru oil on.

[giacomini]

Originally Posted by ThaLowEndTheory

I like to use tru oil on figured wood. I use it on just about every neck I have. Just rub in by hand until it builds. You can apply enough to polish out to a mirror shine, or leave it semi glossy or apply just enough for a satin look. Really pops the grain well. The wood itself makes or breaks the look in the end though. Here's a couple of bodies I used tru oil on.

Those are incredible looking basses!

Don't know which one I like best, the flame or the quilt!

[Dave Higham]

Nice work. Could you explain how you did the burst using Tru Oil?

[ThaLowEndTheory]

Thanks guys, The tru oil is used to pop the grain. Both bodies were dyed, then I applied tru oil by hand. The jazz was of course blue, and the p bass amber. I did not sand back to enhance the figure at all. On the blue I just applied clear nitro. On the P I sprayed the burst using reranch 2 color burst then clear nitro.

[Jazzdogg]

Experiment on a piece of highly-figured scrap.

Apply a coat of relatively dark dye, allow to dry completely, sand thoroughly.

Apply oil-based clear coat.

[Lonnybass]

Originally Posted by Jazzdogg

Experiment on a piece of highly-figured scrap.

Apply a coat of relatively dark dye, allow to dry completely, sand thoroughly.

Apply oil-based clear coat.

+1. Here's a demonstration by Pete Skjold showing this exact technique. It never fails.

http://www.youtube.com/watch?v=u3yMhlEbrOc

Lonnybass