|Kwesi ||10-25-2013 11:51 AM |
Do Squiers and Fenders have the same pickguard shapes?
|Webtroll ||10-25-2013 12:16 PM |
Depends on the Squier I think. I know for a fact that a standard Fender Precision pickguard is not an exact fit on an Indonesian Squier Presicion Special, but it's very close. I know because I replaced the PG on a Special with one that I'd used on a US made P bass and while the pickup and control cavity areas were fine (excepting minor screw hole alignments) the area over the neck on the forward part of the pickguard was actually shorter with the US pickguard, so the screw there was right under the edge of the pickguard.
|gregmon79 ||10-25-2013 12:28 PM |
I can say, IME, no, they dont. I have a '98 Squier P that I bought a fender PG for and I had to drill new holes practically all the way around. Cant remember what the year Fender it was from but it didnt fit perfectly. It still looked good though.
|thisSNsucks ||10-25-2013 12:32 PM |
I'm fairly sure the pickguards on the CV Squiers match up with the Fender Vintage pickguards. I think on the affinities and older models its a little hit and miss.
|BrianToska ||10-25-2013 12:37 PM |
My MIJ Fender precision is the same as my MIK Squier II precision or at least very close. Can't comment on anything other than that though.
|Miskatonic ||10-25-2013 01:08 PM |
Shape? Yes. Holes? Not always.
However, with Fender getting into the direct sales market for necks and bodies this may become a moot issue altogether. They have to standardize parts to get the direct sales thing right, and they're stating that their necks fit both Fender and Squier model basses, which we know that in the past there has been some conflicts.
I know there are a number of people who have stated recently that their VM and CV Squiers share the same hole layout as the pickguards for MIA basses. If they go all in on this plan it's gonna make things so much easier and more fun.
|Malak the Mad ||10-25-2013 10:28 PM |
It depends on the Squier model in question. I had a Fender Jazz pickguard (black pearloid with the truss-rod adjustment notch on the neck pocket…that'd make it for MIA's, right?) match up nicely onto a 2009 Affinity Jazz.
The one's that have been the most problematic for me is the Squier Standard line. When I moved the aforementioned pickguard to a Squier Standard Jazz, I had to take a Dremel tool to the neck pocket, pickup route and the edge against the control plate. I've had similar problems with a couple other Standards too.
|C.Linton ||10-25-2013 10:38 PM |
I compared pics of Fender Precisions to my VM Precision. Now I naturally couldn't tell about the shape and the size, nor if the neck cut would fit, but I did notice That at least one screw on the VM P's guard was in a different position than on the Fenders, about an inch's difference at least. I figure, if the one screw was so far off that I could see the difference in a picture, then I would be suspicious of the others being positioned right.
|All times are GMT -6. The time now is 03:13 AM. || |
Powered by vBulletin® Version 3.6.12
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.