- Stringing B-E-A-D on a 4 stringer.
- Cleaning the body on my Ibanez
- Need a replacement neck for Squier
- Cleaning Wenge fingerboards
- Badass II and Gotoh 201 screw hole spacing
- TRUSS ROD HELP!!!
- Hofner Bass strings slide off saddles
- Ground buzz\hum Issue
- Setup woes with a recently defretted ibanez
- SR500 - Bridge Plating Issue
- Lined to unlined conversion
- Low end fades away on my 4003 Rickenbacker.
- Some intonation problems
- strings buzzing
- Worth it?
- New strings are high!?!?
- my bass is damaged! HELP!
- Fret buzz is driving me nuts!
- Changing out Wilkinson for Hipshot
- Possibly need to re-setup
- 5 string to 4 string?
- A slap plate?
- Fender Jazz cover plates.... again.
- Fret Buzz Question
- Setting up the Ibanez
- Grounding issue hum
- Straplocks for thick leather straps
- string balance problem
- Warwick Input Jack
- Low profile bridge - what's out there?
- What size Allen Wrench for Saddle on MIM Jazz?
- Beginner - Problem Adjusting Pickup Height on MIM Jazz
- Average Setup Cost
- Adjusting Saddles On Hipshot Style Bridge
- Fender Neck Curvature
- adhesive gunk cleaning
- Thinning out a neck?
- My revelation: different basses need different setups
- Cutting an anodized pickguard
- Help wanted!!!:Leo Quan Badass II bridge saddle height adjustment screws
- fret & fret board or neck replacement?
- 20 Fret and 24 Fret intonation difference?
- Quick (probably stupid) Quistion
- Clinky frets! Someone help!!!
- Drop D for Squier
- Will Fender keys fit a Squire (P)?
- how important is the shim?
- Am I too picky?
- Will a Righty P bass nut fit a Lefty P bass neck?
- HELP! growing scratch problem, getting bigger
- spector bridges
- Replacing Internals
- 'Scratching' Problem with Fretless Jazz
- High Fret?
- Problem with Bass, Help!
- question on necks.
- my frets hurt!
- Ibanez Musician Bass 1978
- re-converting fretless to fretted (prob: binding)
- garry willis aluminium spacer ball end trick?
- thumpy carvin
- repainting a bass
- Where to Buy Jazz Bass Knobs with the S-1 Switch?
- WHAT KIND OF SOLDER
- Re-stringing a Dean Pace...
- Volume knob and replacement screws question.
- Filing grooves in Badass II bridge
- Cleaning polyurethane matte bass body
- Allen screws or new bridge....
- Woohoo! I did it!
- Point me in the direction of a good input jack.
- Changing out the neck on my bass
- Is there a website that lists typical string spacings?
- Odd buzz problem
- I Just Got Guitar Player Repair Guide
- So, I Think I Installed My Hipshot D-Tuner Improperly
- I noticed something unique...
- Stripped screws.
- weird, it wasnt like this 5 months ago
- Roundwound set up different than flatwound?
- Drop D Tuning...
- 20 /24 fret
- P-bass pickup cover dimensions?
- Truss rod "automatically" readjusts itself
- Opinions on Allparts necks?
- rec for a nyc tech
- Performed my first fret leveling yesterday
- String clacking
- Comparing these 2 bass's action.
- NOOB Shielding Questions
- my friend removed my bass neck
- drop tuned string tension
- Question on Neck Finish
- Adjusted Truss rod, need opinions
- need help
- Bass Setup in Vancouver?
- Need help with a problem on my bass
- Truss rod and relief tutorial
- jackcord input problem.
- Good 1/4" Jack and 3.5Mm Jack?
- Bass Tech in the Nashville Area
- Raising Pickups
- feedback type noise...
- action toooo hiiiigh - shim the neck joint?
- Set-up issue
- Need a Good Setup in DC/MD
- B-string has low output ..
- Phasing Sound When Plucking Strings
- Best E-book or pdf on setting up basses?
- Drilling holes for the neckplate in the heel of the neck
- strings not in tune up the fretboard
- Neck Replacement
- Bongo Piezo Action Trouble
- Slotting a Stem Tree
- Attaching a Homemade Ramp
- strings slowly sharpening to correct pitch?
- Kahler Tremelo on a Spector
- Sanding the neck
- Need a Good Set-up in NY
- Replacement Bridge for Roscoe Beck V
- Jaco's Fingerboard
- Fret Buzz Help?
- P Body and J neck (part two)
- Help !?! My First finishing project on Carvin Basskit
- graphite neck
- pickup adjustment
- Which Drop D Xtender do I need?
- How to properly setup a dual trussrod (6 string) Please Help
- convert 4 to 5
- Bass Chorus Effect
- adjusting action after setup
- thicker strings
- Rickenbacker pickup cover lopsided
- Fretless too noisy!
- Always in D - need to adjust?
- setting up a Leo Quan Bridge
- Fender Headstock
- Neglected StingRay 5 - Cracked Finish - What to do?
- Strings and Intonation
- Fret Job Question?
- Rickenbacker output jack problem.
- Help needed: bad buzzing on SX Fretless
- Sanding a Fretless Fingerboard (for action)
- Strobe for setting intonation
- Bass not grounded?
- Fretting out while bending notes
- Fret buzz recently after full setup...
- Tone blocks and dead spots
- Does the temp of my house effect my action? 80 degrees?
- michael kelly B string pin - stuck!
- Best Fender Drop-In Replacement Bridge
- Bad ass bass brigde question
- Restoring my Fretboard???
- refinishing a rickenbacker??
- Need Help
- 72 precision fretless intonation setup help
- Essex A# fret buzz
- Fretbuzz problem!
- P Body and J neck
- Just bought a Schecter Stiletto Elite-4
- not sure wat the problem is....
- Too much neck relief-truss rod tightened all the way
- Does anyone sell pickguards *without* screw holes?
- what difference does string-thru actually make?
- tross rod completely loosened, yet no relief
- Intonation
- okok. i need help ..please
- String Volume Out of Wack
- String vibration and chatter with other strings
- Where to find a good place for repair/setup in CT?
- Buzz Feiten tuning
- matching a different neck to a body?
- One buzzing fret-strategies?
- Hohner B2A Schematics/Pic-Help!
- Chip out of neck when bone nut installed???
- E String on Gibson Bass problem
- When changing strings...
- How to Store Bass guitars?
- replacing tuners - some space in headstock ok?
- Bassmute is here
- Buzz/Clicking Problem
- Polyurethane clear gloss finish on the neck(not fretboard)
- Mighty mite neck finish and sanding questions...
- Fretless epoxy question (help a brotha out?)
- Coat on rosewood board
- help, michael kelly truss adjustment
- String buzz
- Oiling help
- applying finish onto a maple neck with rosewood fb?
- Weird sound from my D string.
- What's Wrong With My Bass?
- Removing the neck of a MM
- Replacement Shortscale Necks
- A few questions about making some changes to my bass
- Set up help?
- Setup and then chage the strings?
- My bass has super low volume
- Bridge replacement
- Is something wrong with my neck?
- Routing Body For Vintage-Style Fender Heel-Adjust Truss Rod
- Evil Irishman dismantled my bass!!!
- Reviving burnt Fender MIJ Jazz - many pictures... please help
- Intonation problem on my fretless
- multiple tunings bad for neck?
- Volume Output on Active Pickups
- fret buzz...
- truss rod screw is loose
- A string "hisses" when I slap it.
- How do you lower action?
- Getting correct pickup height
- Boss TU-12 Question
- Fender bridge saddle
- Weak E String
- new p/j pup installation - problem encoutnered
- Filing Badass 2 saddles??
- Oh Crap!! The screw head just came off!!
- dead note?
- Maple necks, what to expect?
- custom bridge!?
- Bridge Ground question
- Fret Job?
- Repair tuning peg???
- Grounding?
- standard tuning, but everythings one fret off
- Is This a Dead Note? + Lowering Pickups
- I've broke my nut!
- refinishing a yamaha trb4 - possible?
- Fender bridges?
- Badass bridge covers?
- P/J Conversion
- Jazz Bass 'Ashtray' bridge cover
- A good strap for changing the bass angle? Maybe?
- Fender Bridge cover for ba II?
- What is the size of the neck pocket on a MIM or MIJ Jazz body?
- Ets-hardware
- Lakland Darryl Jones Tuner size
- Super glue?
- Epiphone Thunderbird Bridge...please help
- Individual string bridge help please!
- This may sound a bit odd...
- ALOT of fretbuzz at first fret, all strings
- Refinishing Experts
- Strangest Set-Up I Ever Did!
- I want to move the strap bolt things?
- Bridge change
- Fret sizes
- New Bass Project help/suggestions needed
- Will a Stat neck plate fit on a J bass?
- Relic Master's
- Lined fretless neck not flat