1. Welcome to TalkBass, the Premier Bass Player Community and Information Source. We've been uniting the Low End Since 1998!

    We're glad you've found us. Register a 100% Free Account to post and unlock tons of features.

'86 Washburn B-10 Wiring

Discussion in 'Pickups & Electronics [BG]' started by Harrisp99, Dec 18, 2013.


  1. Harrisp99

    Harrisp99

    Joined:
    Dec 18, 2013
    Hey, I've been attempting to fix a 1986 Washburn B-10. It has 2 J pickups, a 3-way selection switch, and 3 knobs - a volume for each, and a master tone, which is also a push/pull to switch between active and passive. Two wires- a white and a yellow- are soldered to the preamp, but are loose. I believe they should be attached to the push/pull tone knob, but I am not sure of the configuration. Any insight would be greatly appreciated.
     

Share This Page